Language Español Inglés
Follow Us Add INDEF to my favorites Follow Us on Tweeter Follow Us on Facebook

M-54

Electric furnaces of 1300ºC with Programmer and Gas extraction for gold Fusion and cupellation. 

+ consultar

M-54

Galería

  • M-54
  • M-54
  • M-54
  • M-54
  • M-54
  • M-54
  • M-54
  • M-54
  • M-54
  • M-54
  • M-54
  • M-54
  • M-54
  • M-54
  • M-54
  • M-54
  • M-54

Detalles


Maximum Temperature1300ºC. 
Chamber size: 30cm. Width x 30cm. High x 60cm. Depth.
Furnece size: 127,9cm. Width x 177cm. High x 131,3cm. Depth.
Capacity in liters: 54 liters.
Capacity: 18 crucibles Ø90mm. High 200mm.
Capacity in kilos: 39Kg.
Weigth: 500kg  approximate.
Voltage: 380V c/Neutral 50Hz.
Heating Power: 13kw. / 20 Amp.
Control: Attached to the side of the oven. Contains: Programmer DH-101.
Power Module: Attached to the side of the oven. Contains: (SSR) Solid state relays and general switch.
Gas Exhauster: Elbow 2".
Mufla: Made with panels Indef® of ceramic fiber, portico and hearth of refractory insulation bricks.
Portico: Of insulating refractory bricks.
Heating elements: 6 Silicon carbide heating rods with vertical arrangement and distributed on the two side walls of the muffle. Easy and quick replacement, protected by silicon carbide plates arranged vertically on the side walls. Powered by three-phase power transformer.
Insulation: Indef® ceramic fiber panels.
Floor: Of silicon carbide plates and refractory bricks suitable to support the weight and carry of the load.
Cabinet (structure) with wheels: Manufactured with pipes, angled profiles and plates for industrial use, welded electrically and with termination of thermo-invertible epoxy enamel. Robust front of 1/8 "AISI 304 stainless steel plate for hot door opening.
Power transformer: Located at the base of the oven. Protected with deployed material.
Door: With Maze Lock system to minimize heat losses. Vertical movement up-down; The hot face is always opposite the operator.
Door opening: Pneumatic cylinder opening with 5/3 bidirectional locking electrovalve with three-position up/stop/down lever control.
Power control: Power control: Through three-phase solid-state relays.
Thermocouple: Of Pt Pt Rh 10%, Ø = 0.5mm with bifilares of sintered alumina whose content is greater than 99%. Of Al2O3 and absence of silica to avoid intragranular attack of silicon.
Extraction of gases: It consists of an electro centrifugal fan coupled to the exhaust gas. The extraction is done by Venturi effect, which means that the engine is not in direct contact with the gases. Manual start and stop using key.
Controller: Programmer DH-101 (with PC output).









 

 

You can send your question using the form below.

In the near future we will contact you.

Remember that all fields are required.

Thank you very much.